Maxpro X3 Quint Charger/Balancer

Supports 3cells Li-Polymer batteries ONLY,   5 Channels work respectively

Input Voltage: 13.5 - 24V DC
Charge Current: 1.0 - 3.0A Adjustable in each channel
Max Power: 190W / 15A
Balance Precision: 10mV

1. CHARGE FUNCTIONS

1~5 packs of 3 cells Li-Polymer batteries can be chargerd at one time without same pack capability and cell voltage, there are 5 balance modules in the X3 Quint and provide 1～3A for every pack solely.

e.g.  5 packs of 3 cells Lipo batteries(2000mAh - 2200mAh) will be finished charging in 1 hours with high efficiency.

The blue LEDs shining means the X3 Quint is charging batteries.
The red LEDs flash means the X3 Quint is balancing batteries

The blue & red LEDs dark means the charging is finished

2. BALANCE FUNCTIONS

Voltage balance can be done without DC input.  Users just plug 3 cells Lipo battery (Max 5 packs) into the X3 Quint, then the balancing will run.

The red LEDs flash means the X3 Quint is balancing batteries.
The red LEDs dark means the balancing is finished

Warnings:

• Use a high quality power supply for input power source.

The input voltage must be 13.5~24 V, most of DC Power Supplier can be adjusted in +-1.5%range. Pls make sure the input voltage & power is rich for X3 Quint. if the input voltage is below 13.5V, the batteries will not be fully charged.

• X3 Quint can charge 3cells Li-Polymer batteries ONLY. Don't charge other types & cells of battery.
• Be sure that your Lipo battery pack balance connector & polarity match the type connected to the charger.
• Beware that the temperature of the charger shell & battery packs will increase during charge at high power.
• Do not exceed the battery manufacturer's suggested maximum charge rates.
• Never charge batteries unattended.
• Properly insulate and regularly inspect all connectors to eliminate the possibility of short circuit.
• Do not open the case of the charger under any circumstances.  Doing so will void the warranty.